how to remove front panel on bathtub

Score the ends and bottom of the skirt where the silicone caulk is with the utility knife. Remove side of tub by removing screws first.

How To Remove And Replace A Bathtub The Home Depot

Grab the corner panel from the bottom centre.

. Step 2 Pry the caps off the skirt with the blade of a utility knife. Remove any sealant that was used to fix the panel in place and check the. Set the panel to the side.

Apply the adhesive on the decorative paneling and fix it on the front of the tub. The choice of adhesive is based on the panels you bought. I was surprised at how easy it was to pop out my old bath panel.

Pull on the access panel to dislodge the upper lip of the panel. What Ive seen done to remove the front panel is to remove all the caulk around the edges to break the seal then pull on it with a couple of suction cups or plungers to pull it. How to remove the easy access front panel on your 2020 Self-Cleaning hot tub.

See the old tub front panel pictured below. Step 3 Remove the screws securing the. Do not over tighten your screws.

Always use fitted washers and. Although there was nothing. Break the Silicone Mounting Seal.

Replacing my bath panel was easier than I expected and definitely a job that we ladies can tackle ourselves. Hold your panel up to the side of your hot tub and line up the screw holes. Step 3 Installation.

Take the measurements of the front panel of your tub. Work your hand around the access panel pulling the access as you go around the sides. Mine measured L1575cm and H46cm.

Pull up on the pry bar. Pull the bottom of the corner panel out away from the hot tub then pull it down to remove be careful of exterior lighting wires if installed. Apply the adhesive on the decorative paneling and fix it on the front of the tub.

Screw in the screws with a drill or screwdriver. Woodies will show you how to replace a bath panel.

Standard Bathtub Sizes Guide To Common Tub Sizes